View Single Post
Old 2007-05-06, 13:47
Koshdukai's Avatar
Koshdukai Koshdukai is offline
Join Date: Mar 2007
Posts: 4,069
No need for manual selection of notch mode.

: This mode could be selected automatically, because the knob can query/access the type of values of the target it controls.

So, there's no need for a menu-driven NOTCH mode selection. The knob would simply be in the correct mode depending on the target parameter. Either in continous value mode (0..127 or -64..+64) or notch mode (with as many steps as the controlled paramater requires), automatically.

This is possible, useful and required for a proper use of the Combinator knobs with non-continous value parameters.

Last edited by Koshdukai; 2009-05-04 at 03:38. Reason: link update